vovazero.blogg.se - Hanging pictures on plaster walls

#Hanging pictures on plaster walls install#
#Hanging pictures on plaster walls windows#

Brick and concrete walls require drilling a hole with a special masonry bit then either hammering in a masonry nail or using a plastic anchor and screw. While you can nail or screw directly into drywall, always drill a pilot hole first in plaster to prevent cracking. To make sure you get it right, position the lowest point of the hook at the mark before attaching the hardware to the wall. Keep in mind that the spot marked on the wall and the location you attach the hanger may differ since the hook often extends down from the nail or screw that holds it.

#Hanging pictures on plaster walls install#

They are quick to install and remove, leaving a very small hole that is easy to spackle and paint over. Wire hangers will only work where there’s not a stud or other obstruction in the wall. To use, simply twist the sharpened point through the drywall and push the wire into the wall cavity until it locks in place. The latest innovation in picture hanging hardware is a thin curved spring steel wire sold under brand names such as Heavy Duty Wall Hanger, Hercules Hook, and Monkey Hook. Self-tapping threaded anchors are suitable for attaching all but the heaviest pictures to drywall.Īnchors that spread out behind the wall-such as toggle or molly bolts-provide the most holding power and help keep plaster from cracking. If the picture is heavy and a stud isn’t present, you’ll need to use a wall anchor on drywall or plaster walls. If the hanging hardware will attach to a wall stud or solid wood paneling, just about any hanger suitable for the frame and rated for the weight of the picture will do. Traditional metal picture hooks work well for lightweight frames fitted with wire while screws or nails are a better choice for sawtooth and D-rings hangers. To find the weight of the picture, weigh yourself on a bathroom scale while holding the picture then subtract your weight from it.

There are a number of hardware options for hanging pictures, with the label on the package usually giving the maximum weight each one is designed to hold.

If the wall hanger will be attached to a stud.

The type of hanging hardware on the frame.

In order to select the right hardware to hang your picture, you need to know: Then use a level to make sure it is plumb with the mark on the strip of tape. Transfer the hanger location on the wall by measuring down from the bottom edge of the painter’s tape. Pull up until the wire is taut, and measure up to the top of the frame.įor frames with a wire that will have two hanging points, pull up on the wire at both points simultaneously then measure up to the top of the frame.įor pictures with D-rings or sawtooth hangers, hook the tape over the top of the frame and measure down to the spot where the wall hanger will be attached. For pictures with a hanging wire and one hanging point, hook the metal end of a tape measure under the center of the wire. Next, turn the picture over and measure from the top of the frame to the point the picture will hang. If the frame has a hanger on each side, measure in from the outside edge of the frame to the center of each hanger and transfer these measurements to the tape. Split any difference between the two marks for the center.įor added stability on wide frames, use two hangers that are equidistant from the center point.

If the picture will have only one wall hanger, find the width of the frame, divide by two, and measure this distance in from the marks on the painter’s tape.

Mark each end of the frame on the tape then remove the picture. While holding the picture in place, put a strip of painter’s tape on the wall with the bottom edge even with the top of the frame.

Lighted Magnifying Glass That Stays Put.

#Hanging pictures on plaster walls windows#

Single vs Double Vs Triple Pane Windows.